|
 |
|
                    |
Never install the throttle servo near the engine. Put it back with the rest of the servos and use Nyrod as push rod. Use a ball link on the throttle arm to eliminate play and vibration Place the ignition battery and ignition switch toward the front of the plane if electronic ignition is installed. Place the radio battery and switch behind the throttle servo and as far back as possible Keep as much separation as you can between ignition system and radio system components. Keep at least 2 to 3" separation between RX antenna and extension wires. Install a plug shield if your engine does not have one. Always use a resistor plug |
           |