CONTENTS

SETTING UP THE SERVOS

1. Plug the right elevator into channel 2
2. Plug the left elevator into channel 5

SETTING SERVO TRAVEL DIRECTION

1. Turn on the transmitter
2. press both edit buttons to open menu
3. Check your Programmable mixers to insure that servo channels 2 and 5 are not being used. 
4. Press the up or down edit button until AILV appears in your transmitters window.
5. Turn on or activate the AILV feature by pressing the active/inhibit (clear) key.  (The display will change from "inh" to on)
6. At this point both elevator servos should move.  
7. They should move in the same directions
8. If they do not move in the same directions press the right curser button to get to the travel settings menu
9. The transmitter window will display AIVL (+ 0r -) 100
10. The + or - signs indicate which way the servos travel.  Changing that sign will reverse the servos
11. If the right elevator moves in the right direction skip to line 16.
12. If the right elevator moves in the wrong direction press the right curser key until you see the master and slave arrows above and below CH 2.
13. Hold down the opposite data  button to change the direction.
    Example:  
    Problem  The right elevator reads +100 and moves in the wrong direction
    Solution   hold down the - data button until the window displays - 100.
14. The right elevator should now move in the right direction.
15. If the left elevator moves in the wrong direction press the right curser key until you see the down arrow above CH 2 and the up arrow below CH 5
16. Hold down the opposite data  button to change the direction.
    Example:  
    Problem  The left elevator reads -100 and moves in the wrong direction
    Solution   hold down the + data button until the window displays + 100.
17. The left elevator should now move in the right direction.
18.  

SETTING UP ELEVATORS TO MOVE IN OPPOSITE DIRECTIONS FOR TIGHTER ROLLS

If the elevators move opposite each other when pushing the right stick left or right then skip this section.

1. If they do not move opposite press the right curser button until the down arrow is above CH 1 and the up arrow is below CH 5
2. The window will display AILV (+ or -) 100
3. Press and hold the + or - data button until the + or minus sign changes
4. Continue holding down the button until it reads 100 again

ADJUSTING ELEVATOR TRAVEL